EMT Practice Test

1. Question Content...

---

Question1: Where should sx_api_ports_dump.py command be ran?

Question2: For the MHO-175, which ports are Management ports?

Question3: What cannot be learned from the output of asg monitor command?

Question4: What kinds of transceivers are supported on Orchestrator MHO-170?

Question5: What does asg monitor command do?

Question6: What happens if the SMO Master fails?

Question7: There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

Question8: What can be learned from the output of sx_api_ports_dump.py command?

Question9: What is the throughput penalty of Security Group?

Question10: What is the purpose of g_tcpdump command?

Question11: In a dual MHO environment, MHO1 and MHO2 are connected to the SGM line cards in which way?

Question12: What does the lldpctl command do?

Question13: What type of cluster can a Security Group can be compared to?

Question14: In a Maestro Dual Site environment, what is the definition of the term Active Site.

Question15: Maestro allows running commands globally in Expert mode by using global prefixes, such as:

Question16: The drop_monitor command is useful for

Question17: What is the Correction Layer?

Question18: Possibilities for a failure in a single SGM of a Security Group include.

Question19: There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for downlinks' intra- orchestrator redundancy when using two Orchestrators?

Question20: What cannot be learned from the output of lldpctl?

Question21: What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on
"Orchestrator" in WebUI

Question22: What is one benefit of a Dual MHO environment?

Question23: Complete the sentence: Dual Orchestrators work as.______

Question24: What kinds of transceivers are supported on Orchestrator MHO-140?

Question25: What is the difference between Dual-Site and Dual-Room?

Question26: Which distribution mode assigns packets to an SGM based solely on the packet destination IP?

Question27: Which licenses should be issued for the Orchestrator?

Question28: What command should be used for collecting diagnostic information about the orchestrator?

Question29: How does HyperSync work in a Dual Site environment?

Question30: During an upgrade, Is Multi-Version Clustering (MVC) supported?

Question31: What will happen in case of NAT of the traffic passing through Management network?

Question32: What is a downlink interface used for?

Question33: Do all MHOs need to be upgraded before starting the SGM upgrades?

Question34: What is the maximum number of Appliances within the same Security Group?

Question35: Which command do you use to find bottlenecks in the system that are affecting performance, even functionality in some cases?

Question36: What Maestro component acts as a load balancer and network switch?